Guide
Connect to Wi-Fi with the mobile app
Set up Atmos and add it to your home in the HomeBrainz Hub app on Android or iPhone.
Before You Start
The HomeBrainz Hub app connects Atmos to your Wi-Fi and adds it to your home in the app, in one flow.
- The HomeBrainz Hub app from Google Play or the App Store, signed in to your account.
- A powered Atmos in setup mode. In setup mode it creates a Wi-Fi network named inkVision-XXXXXX.
- The name and password of your 2.4 GHz home Wi-Fi network.
- Your phone near the clock, with Wi-Fi turned on.
- On its setup network the clock answers at 192.168.4.1, or 192.168.1.1 on older firmware. The app tries both.
Android
- Open the app and select Add Device.
- Allow the Wi-Fi, location and local network permissions if Android asks for them.
- Wait while the app looks for nearby devices, then select your clock's inkVision-XXXXXX network and choose Connect.
- Choose your home Wi-Fi from the list, or select Network not listed? Enter manually.
- Enter the Wi-Fi password and select Connect Device.
- Wait while the clock restarts, joins your Wi-Fi and registers. The app shows Device Connected! when it is done.
iPhone
iOS does not let apps join a Wi-Fi network by themselves, so you join the clock's setup network in Settings once.
- Open the app and select Add Device.
- When the app asks, select Go to Settings and open Wi-Fi.
- Join the inkVision-XXXXXX network. Stay on it even if iOS says No Internet Connection. Turning off mobile data helps.
- Return to the app and select I'm connected.
- Choose your home Wi-Fi from the list, or enter its name manually.
- Enter the password and select Connect Device.
- When the app asks, switch your iPhone back to your home Wi-Fi.
- Wait until the app shows Device Connected!.
After Setup
- The inkVision-XXXXXX setup network disappears.
- Atmos appears in your home in the app, with temperature, humidity, pressure and air quality.
- You can add it to Home Assistant as well. See Connect to Home Assistant.
Troubleshooting
- The app does not find the clock: check that inkVision-XXXXXX appears in your phone's Wi-Fi list, move closer and select Scan Again.
- The iPhone keeps switching to another network: rejoin inkVision-XXXXXX in Settings > Wi-Fi, turn off mobile data and return to the app.
- The app cannot list Wi-Fi networks: enter your network name manually.
- Connection Timeout: check the Wi-Fi password and that the network is 2.4 GHz, reconnect your phone to your home Wi-Fi and select Try Again.
- If the app still does not work, set up Wi-Fi in a browser instead with the manual Connect to Wi-Fi with AP mode.