Connect to Wi-Fi with AP mode

Use this method when you want to connect the device directly from a phone, tablet, or computer browser.

• You need a powered Atmos device in setup mode.
• You need the name and password of your home Wi-Fi network.
• You need a phone, tablet, or computer with Wi-Fi.
• In setup mode, the device creates a temporary open Wi-Fi network named inkVision-XXXXXX.
• The local setup page is available at http://192.168.1.1.

1. Power on the Atmos device.
2. Wait for the device to enter setup mode.
3. On your phone, tablet, or computer, open the Wi-Fi settings.
4. Join the network named inkVision-XXXXXX.
5. If your device warns that the network has no internet access, stay connected anyway.

1. Open a browser.
2. Go to http://192.168.1.1.
3. Wait for the Configure WiFi page to load.

If the page does not open, confirm you are still connected to the inkVision-XXXXXX network, disable mobile data or VPN temporarily if the browser keeps switching away from the local page, and refresh once after reconnecting.

1. In the WiFi SSID field, enter your home Wi-Fi network name.
2. In the WiFi Password field, enter your Wi-Fi password.
3. Select Save WiFi.

• The device saves the credentials.
• The device restarts automatically.
• The temporary inkVision-XXXXXX setup network disappears after the restart.

After the restart, reconnect your phone or computer to your normal home Wi-Fi and confirm that the device is online.

• Check your router or DHCP client list for the new device.
• Use a local network scanner.
• If your network resolves local hostnames, try adding the device from Home Assistant discovery first.

Once the device joins your home Wi-Fi, you can open its local pages from any browser on the same network.

1. Open http://DEVICE_IP/.
2. Use the inkVision Device Dashboard to review device status, live sensors, brightness, screen rotation, OTA check or install actions, and restart controls.
3. Open http://DEVICE_IP/ota if you need the dedicated firmware upload page for a local .bin file.
4. Keep note of the device IP address because you can use the same address later in Home Assistant.

If the setup Wi-Fi network does not appear, power-cycle the device, wait about 30 seconds, and scan for Wi-Fi networks again. Move closer to the device during first setup.

If the setup page opens but saving fails, re-enter the SSID and password carefully and stay connected to the inkVision-XXXXXX network until the browser confirms the request was sent.

If the device restarts but never appears on the home network, repeat the AP-mode setup once and check the router's connected devices list for a new hostname or MAC entry.