inkVisioninkVision

Guide

Use inkVision Voice

Wake words, buttons, timers, music, mute, the climate sensor (Voice Plus), the LED ring and factory reset.

Talk To It

  • Say the wake word, for example “Hey Vizzy”, then your request: “turn off the living room lights” or “what's the weather like?”.
  • Or press the play button twice and speak without the wake word.
  • If it did not understand you, it says so and the ring flashes red.

The Buttons

  • Volume + and volume −: change the volume. The ring shows the level for a second, from green to red.
  • Play, one press: pauses or resumes music, or stops a ringing timer or a spoken answer.
  • Play, two presses: starts talking without the wake word.
  • Play, hold for 1 second: mutes or unmutes the microphones.
  • BOOT, hold for about 3 seconds until the ring turns red, then release: turns the device off. A short press turns it on again.
  • RESET: restarts the device.

Timers

  1. Say “Hey Vizzy, set a timer for 5 minutes”.
  2. The ring shows the time left as yellow segments.
  3. When the timer ends, the device beeps every 2 seconds for up to 15 minutes.
  4. Say “stop”, with no wake word, or press play once to silence it.

Music And Announcements

inkVision Voice appears in Home Assistant as a media player, so Music Assistant and your automations can play music, radio and announcements on it. Music gets quieter by itself while the assistant listens or speaks. Saying “stop” also ends a spoken answer.

Mute And Sounds

  • Hold play for 1 second to mute the microphones. You hear a falling tone and the ring turns dim red. Hold it again to unmute.
  • You can also use the Mute switch on the device page in Home Assistant. Mute stays on after a restart.
  • The Wake sound switch on the device page turns off the short chime after the wake word.

Temperature And Humidity (Voice Plus)

On Voice Plus, the built-in sensor reports Temperature and Humidity to Home Assistant. If the temperature differs from a reference thermometer, set the Temperature calibration slider on the device page, from −15 °C to +15 °C. The setting is kept after a restart.

What The LED Ring Shows

  • Off: ready.
  • Blue: listening.
  • Cyan, moving: thinking.
  • Green, pulsing: answering.
  • Red: error, or it did not understand you.
  • Dim red: microphones muted.
  • Yellow segments: a timer is running. Yellow, pulsing: a timer is ringing.
  • Amber, pulsing: looking for Wi-Fi. Dim amber: on Wi-Fi, but no connection to Home Assistant.
  • Purple, pulsing: waiting for setup. Dim purple: the setup window has closed; unplug the device and plug it back in.
  • White: factory reset in progress.

Change The Wi-Fi Network

  1. Power the device on where the old network is not available.
  2. After 90 seconds the ring pulses purple.
  3. Press play and give it the new network from the Home Assistant app, as in the setup manual.

Factory Reset

A factory reset erases the saved Wi-Fi, the Home Assistant key and the device settings. Set the device up again afterwards.

  • Press RESET 5 times, each press within 10 seconds of the last. The ring gets brighter white with each press.
  • Or hold volume + and volume − together for 10 seconds.
  • Or select Factory reset on the device page in Home Assistant.